|
****JavaScript based drop down DHTML menu generated by NavStudio. (OpenCube Inc. - http://www.opencube.com)****
|
Do you suspect that your pool water may be leaking? Are having to refill your pool water every week or two and can’t figure out why?
Here is a sure fire way to test if your pool is leaking and how quickly, using nothing more than a five-gallon bucket and a roll of masking tape or marker:
|
|
The "Bucket Test"
- Bring pool water to normal level.
- Fill a 5 gallon bucket with pool water approximately 3-4 inches from the top.
- Place the bucket on the first or second step of pool (preferably the second step without immersing it).
- With a marker or electrical tape, mark the water level on inside of bucket.
- Shut off pump and mark pool level on outside of bucket.
- Resume normal pump operation. Make sure auto/manual fill valve is off during test.
- After 24 hours, compare the two levels. If the pool water (outside mark) goes down more than the inside water level, there may be a leak.
|
Here is how to determine whether or not your swimming pool is leaking, or if you are simply experiencing reduced water levels caused by evaporation:
Check the outside mark. If the pool water level has gone down more than the inside water level, there may be a leak. If both the inside and outside water levels have decreased at the same rate, there's a good chance you are experiencing nothing more than evaporation.
Note: The bucket test must only be done on clear nights, so check the forecast. If it rains, the pool bucket test won't work. |
|
An unrepaired hole the size of a pencil tip can result in hundreds of gallons of water loss per day. An increase of water need, means in increase in chemical demands which could lead to more serious mechanical and structural issues. The longer the leaking pipe, pool shell or liner is left unrepaired the more money it will cost to repair.
|
You can tie the bucket to a hand rail or something so it doesn’t get knocked over or into the pool.
If you need to weigh the bucket down with something, let whatever you use absorb the water before marking the bucket.
The water levels do not have to be the same. We need to see if the pool goes down more from its mark than the bucket does from its mark. (The bucket will only evaporate.)
We suggest running this test with the pump off for 24 hours and then running the test again with the pump on for 24 hours. Write down the results! This helps us to narrow down were the leak might be and can save you money if you need us to find it.
- Do not add water or backwash the filter during the test.
- Do not allow swimming during this time.
- Do not let the dog drink out of the bucket.
- If it rains, run the test again.
|
|
If you suspect you have a leak we will find it! Contact us today for a free estimate! If you have any questions or we can assist you in any way, please contact contact The Right Way leak Detection and Repair, Inc. at 972-754-8173. For your convenience, you may also request services from this site.
|
|
Thank you for your interest in The Right Way Leak Detection and Repair, Inc. We look forward to serving you in the near future. |
Emergency Service Available
|
Don't Let Your Pool Drain You, Let Us Fix It, The Right Way!
|
Open 7 Days A Week |
 |
972-754-8173 |
8 a.m. - 5 p.m. |
|
Free Estimates |
Call Us Today! |
Bonded & Insured |
|
Home
| Services
| Leak Detection
| Repair Services
| Remodel Services
| Bucket Test
| F.A.Q.
| Request Services
© 2011 The Right Way Leak Detection and Repair, Inc. All rights reserved.
Website Design by Brymels & Associates.
DHTML Menu / JavaScript Menu Powered By OpenCube
| |